Drawing oil

Examples of Application
·  Drawing of tubes and wires
·  In calibrating drafts without internal tool, this product is used for the OD lubrication
·  Finishing oil for the ID lubrication in the final pass of drawing tubes

·  Copper
·  Brass

·  Contains mineral oil
·  Chlorine, phosphorus and sulphur free *

Characteristic data
·  Appearance : yellow, clear fluid


Density at 20 °C

g/cm3 0.86 – 0.88

AA_003-9 acc. to DIN 51757/5

Kin. viscosity at 40 °C

mm2/s 9 – 14

AA_003-133 acc. to DIN 51562

Flash point

°C ≥ 120

AA_003-125 acc. to DIN EN ISO 2592

Pour point

°C -10

AA_003-129 acc. To DIN ISO 3016


Instructions for use

·  In the following annealing process the remaining film of the drawing oil evaporates practically residue free.

·  Drawing oil remnants in relevant solvents can also be removed easily

·  Storage : Container to be stored under dry and frost protected conditions. Temperature range +5 °C to +30 °C

* Chlorine, sulphur or phosphorus are not part of the product formulation